微杏十年网页入口

Wuhan generator set products are sold throughout Hubei, including Jingzhou, Jingmen, Huangshi, Xiaogan, Huanggang, Yichang, Suizhou, Tianmen, Xiantao, Qianjiang, Ezhou, Xianning, Yingcheng, Hanchuan, Xiangyang and Shiyan.

Wuhan Genset Service Hotline: 186 2700 7668

Wuhan Wacker Power Technology Co., Ltd. R & D, sales, after-sales maintenance and environmental protection installation of generator sets

Popular keywords: Cummins generator, Weichai generator, Yuchai generator, Volvo generator, Shangchai generator

Generator price

How to deal with water after Xiantao diesel generator set is running

阅读:82次 发表时间:2019-08-28 Article Source: Wuhan Generator Leasing Company Read: 82 Times : 2019-08-28

At present, it is understood that some users have performed some improper operations in the operation of diesel generator sets, such as accidentally letting water enter the generator set. So what will happen when this happens? What is the follow-up treatment method? The following is about diesel How to deal with the water after the generator set is running for a brief introduction

1. The diesel generator set cannot be turned on immediately after entering the water. The appearance of the diesel engine is washed with water to remove dirt and debris, and then the surface is cleaned with a metal cleaner or washing powder.

2. One end of the diesel generator is set so that the parts of the diesel engine oil pan and oil drain are at the lowest position. Unscrew the oil plug and pull out the oil scale to disengage itself from the oil pan. After the water is together, screw on the oil drain plug.

3. Remove the air filter, remove the housing from the filter, remove the filter element, remove the water from the filter, and clean the parts with a metal cleaner or diesel. The filter is made of plastic foam. Wash with washing powder or soap, then rinse with water, wipe dry, and soak with an appropriate amount of oil. When replacing a new filter, soak the oil. The filter element is paper and should be replaced with a new one. After cleaning and drying all parts of the filter, install it as specified.

4. Remove the air intake pipe, exhaust pipe and muffler to eliminate internal storage. Open the pressure reducing valve and open the diesel engine to see if there is water inlet and outlet. If water is discharged, continue to roll the crankshaft and the water in the cylinder will be completely cleaned. Install the intake pipe, exhaust pipe and muffler, add a little oil to the air intake, rotate the crankshaft several times, and then install the air filter.

5. Remove the fuel tank and remove all oil and water. Check the diesel filter and tubing for water. If there is water, it should be clean. Clean the fuel tank and diesel filter, then put it back in place, open the oil, and add clean diesel to the fuel tank.

6. Drain the water tank and water channel, and clean the water channel. Turn on the throttle switch, start the diesel engine, and watch the oil indicator rise after starting the diesel engine. Listen for any unusual sounds from the diesel engine. After checking the normal part of each part, during the operation of the diesel engine, the first idling speed, medium speed and high speed, and the running time are 5 minutes. After grinding, the oil will be released and the new oil will restart the diesel engine. The engine will run at a moderate speed for 5 minutes and it can be used normally.

7. Disassemble the generator and check whether the stator inside the generator has a rotor, and then dry it before assembly.

The above is a brief introduction on how to deal with water after the diesel generator set is running. I hope this knowledge will help you!